Entering the Personalization Menu

Base Audio System 

To enter the Feature programming mode use the following procedure:

1. If the vehicle has memory settings, press the appropriate memory button, 1 or 2, located on the driver door armrest. The driver information center (DIC) display will show either Driver 1 or 2 depending on which button was selected.
2. Turn the ignition to ON without the engine running. Make sure an automatic transmission is in PARK (P) or a manual transmission has the parking brake set.
3. Press the scroll/select knob once to access the main menu of the DIC.
4. Turn the scroll/select knob until SETUP is highlighted.
5. Press the scroll/select knob once to access the SETUP menu.
6. Scroll to the PERSONALIZATION menu item and select it to access the PERSONALIZATION menu.
7. Press the scroll/select knob until a check mark appears after the PERSONALIZATION menu item. This turns on the personalization feature. If you see a minus sign (-) after the PERSONALIZATION menu item, the personalization feature has been turned off.

Navigation System 

To enter the feature programming mode use the following procedure:

1. Turn the ignition to ON without the engine running. Make sure an automatic transmission is in PARK (P) or a manual transmission has the parking brake set.
2. Turn on the Navigation/audio system by pressing the power/volume knob located to the lower left of the display, once.
3. Access the DIC main menu by pressing the Audio Setup button located to the lower left of the display.
4. Press the button with the dot on it next to Feat Prog to access the Feature Programming menu.
5. Press the scroll/select knob to turn on the Personalization features. An X will appear in the box to the left when Personalization is turned on.

Now you are ready to program the personalization features. The following choices are available for programming using both the Base audio and Navigation systems unless otherwise indicated.