Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> CTS Base, 2.8 T, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.8L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the CPK sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CPK bolt.

    Tighten:  Tighten the CPK bolt to 10 N.m (89 lb in).

    3. Fig 2: Locating CKP Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP electrical connector (3).
  4. Install the wiring harness heat shield to the oil level indicator tube.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals