Installation Procedure
WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Position the generator near the installed position.
- Connect the battery positive lead to the generator and install the generator output battery terminal nut.
Tighten: Tighten the generator output battery terminal nut to 12.5 N.m (111 lb in).
- Press the protective boot on to the generator output BAT terminal.
- Connect the wiring harness connector to the generator.
- Position the generator to the generator bracket on the engine.
- Install the lower generator mounting bolt, but do not tighten at this time.
- Lower the vehicle.
- Install the upper generator mounting bolts.
Tighten: Tighten the generator mounting bolts in the sequence shown to 50 N.m (37 lb ft).
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Install a new tie strap to secure the wiring harness to the generator.
- Install the right and left side stabilizer shaft links to the lower control arm. Refer to Stabilizer Shaft Link Replacement in Front Suspension.
- Install the right side wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front in Body Front End.
- Install the front wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Install the front air deflector. Refer to Air Deflector Replacement - Front in Body Front End.
- Lower the vehicle.
- Install the generator drive belt. Refer to Drive Belt Replacement - Generator in Engine Mechanical - 4.6L (LH2).
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.