Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System - 4.6L (LH2) - Introduction) >> Repair Instructions >> Ignition Control Module Replacement - Bank 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Coil Cover - Bank 1
    GM1235151Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 4.6L (LH2).
  2. Remove the ignition coil cover from the cam cover by lifting straight up.
    3. Fig 2: View Of Engine Wiring Harness & Right Ignition Coil Harness
    GM927822Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the ignition module assembly wiring harness electrical connector.
    4. Fig 3: View Of Ignition Coils
    GM928257Courtesy of GENERAL MOTORS CORP.
  4. Remove the ignition module assembly retaining bolts and studs.
  5. Carefully, remove the ignition module assembly.
scientia non olet · About Mike's Workshop Manuals