Circuit/System Verification
P0641
- Observe the MAP sensor voltage parameter with a scan tool with the ignition ON and the engine OFF. The scan tool should display approximately 2.2 volts for a normally operating system.
- Engine running, observe the DTC information with a scan tool. DTCs P0641 or P0651 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
P0651
- With the ignition ON and the engine OFF, observe the APP sensor 1 voltage parameter with a scan tool. The scan tool should display approximately 0.96 volt for a normally operating system.
- Engine running, observe the DTC information with a scan tool. DTCs P0641 or P0651 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.