Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2006 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 4.4L - DTC P0010 To P0175) >> DTC P0106 >> Component Test

Component Test

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: You must perform the circuit/system verification before proceeding with the circuit/system testing.
  1. Ignition OFF, remove the MAP sensor.
  2. Install a 3A fused jumper wire between the 5-volt reference terminal of the sensor and 5 volts.
  3. Install a jumper wire between the low reference terminal of the sensor and ground.
  4. Ignition ON, install the J 35555  to the MAP sensor vacuum fitting. Slowly apply vacuum to the sensor while monitoring the voltage between the signal terminal and the low reference terminal. the voltage should vary between 5-0 volts, without any spikes or dropouts.
    • If the voltage is not within the specified range or is erratic, replace the MAP sensor.
scientia non olet · About Mike's Workshop Manuals