Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2006 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 4.4L - DTC P0010 To P0175) >> DTC P0101 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the MAF sensor.
  2. Ignition OFF, test for less than 5 ohms of resistance between the ground circuit terminal B and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, test for 4.8-5.2 volts between the MAF sensor signal circuit terminal A and ground.
    • If less than the specified range, test the MAF sensor signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the control module.
    • If greater than the specified range, test the MAF sensor signal circuit for a short to voltage. If the circuit tests normal, replace the control module.
  4. Ignition ON, verify that a test lamp illuminates between the MAF sensor ignition 1 voltage circuit terminal C and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  5. Connect the J 38522  to the vehicle. Refer to Component Testing.
scientia non olet · About Mike's Workshop Manuals