Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating CKP Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Reposition the wiring harness heat shield to obtain access.
  4. Disconnect the crankshaft position (CKP) electrical connector (3).
    5. Fig 2: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft sensor bolt.
  6. Remove the crankshaft sensor.
scientia non olet · About Mike's Workshop Manuals