Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2006 >> DTS 4.6 9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.6L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: CKP Sensor Wiring Harness
    GM1672927Courtesy of GENERAL MOTORS CORP.
  4. Connect the CKP sensor wiring harness electrical connector (1) to the CMP sensor.
scientia non olet · About Mike's Workshop Manuals