Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.6L (Ly7) - Introduction >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Intake >> Installation Procedure

Installation Procedure

    Fig 1: View Of Right CMP Sensor - Intake
    GM1285251Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Right CMP Sensor Electrical Connector - Intake
    GM1285245Courtesy of GENERAL MOTORS CORP.
  3. Connect the CMP sensor electrical connector.
  4. Install the front compartment sight shields as necessary. Refer to Sight Shields, Hood Adjuster, Hood Bumper, Hood Latch Replacement in Body Front End.
scientia non olet · About Mike's Workshop Manuals