Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Bracket Replacement (LH2) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Generator Bracket Bolts - LH2
    GM887717Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket to the engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bracket bolts.

    Tighten:  Tighten the generator bracket bolts in the sequence shown to 50 N.m (37 lb ft).

  3. Install the right side engine mount bracket. Refer to Engine Mount Bracket Replacement - Right (w/RWD) or Engine Mount Bracket Replacement - Right (w/AWD) in Engine Mechanical - 4.6L (LH2).
  4. Install the generator drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Generator in Engine Mechanical - 4.6L (LH2).
  5. Install the generator. Refer to Generator Replacement (LY7)  or Generator Replacement (LH2 w/AWD)  or Generator Replacement (LH2 w/RWD)  in Engine Mechanical - 4.6L (LH2).
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About Mike's Workshop Manuals