Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.8L, 5.3L & 6.0L - Introduction >> Repair Instructions >> Fuel Sender Assembly Replacement (6.0L Engine - Dual Tanks - Rear) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Vapor Line Quick Connect Fittings (Rear Tank)
    GM1372821Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW fuel tank module seal onto the fuel tank.
  2. Position the fuel tank module part way into the fuel tank.
  3. Connect the vapor line quick connect fittings to the module. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Install the module into the fuel tank.
  5. Place the lock ring into position.
    6. Fig 2: Rotating Lock Ring Using J 45722 (Rear Tank)
    GM1372822Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the tool does not come in contact with the module pipes while unlocking the lock ring.
  6. Using J 45722  , rotate the lock ring clockwise in order to lock the ring. See Special Tools .
    7. Fig 3: View Of EVAP Lines At Fuel Tank Module (Rear Tank)
    GM1372819Courtesy of GENERAL MOTORS CORP.
  7. Connect the EVAP lines to the fuel tank module. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  8. Install the rear fuel tank. Refer to Fuel Tank Replacement (Single Tank)  or Fuel Tank Replacement (Dual Tanks - Front)  or Fuel Tank Replacement (Dual Tanks - Rear)  or Fuel Tank Replacement (Single Tank w/5.3L (L59) Engine) .
scientia non olet · About Mike's Workshop Manuals