Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> DeVille Protection Series >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Torque Converter Clutch/Cruise Control Release Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Brake Pedal & Stop Lamp Switch
    GM575743Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the brake pedal switches, ensure that the brake pedal remains in the full up or at rest position.
  1. Connect the upper switch (1) electrical connector.
  2. Install the upper switch (1) into the upper retainer.
  3. Twist the switch clockwise until fully seated.
    4. IMPORTANT: The release switch assembly and the stoplamp switch assembly cannot be adjusted until after the brake booster pushrod is assembled to brake pedal assembly. Incorrect adjustment may cause the cruise control system to not work properly.
  4. Adjust the switch. Refer to Torque Converter Clutch/Cruise Control Release Switch Replacement .
  5. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About Mike's Workshop Manuals