Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> DeVille Protection Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine Controls - 2.8L - Introduction) >> Repair Instructions >> Intake Manifold Runner Control Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold Runner Control Solenoid
    GM1285195Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold runner control solenoid.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intake manifold runner control solenoid bolts.

    Tighten:  Tighten the intake manifold runner control solenoid bolts to 10 N.m (89 lb in).

  3. Install the upper intake manifold. Refer to Intake Manifold Replacement - Lower in Engine Mechanical - 2.8L (LP1).
scientia non olet · About Mike's Workshop Manuals