Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connector to the cruise control module (1).
Install the cruise control cable (3) to the cruise control module assembly buckle (2).
Snap the cruise control cable (3) into the cruise control module (1).

Fig 1: View Of Cruise Control Cable & Module Buckle

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable. Refer to Cruise Control Description and Operation for the complete operational details.

Install the cruise control cable (2) to the engine bracket.
Verify that the tab on the cable is engaged.
Hold the throttle open and slide the cruise control cable fitting (2) onto the throttle cam pin (1).

Fig 2: View Of Cruise Cable Fitting & Pin (Base, DHS, DTS)

Courtesy of GENERAL MOTORS CORP.

Install the clamps around the cruise control cable (1) and the accelerator cable.

Fig 3: View Of Cruise Control Cable (Base, DHS, DTS)

Courtesy of GENERAL MOTORS CORP.