Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> DeVille Protection Series >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Secondary Air Injection (AIR) Pump Intermediate Pipe/Hose Replacement - Bank 1 >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Bank 1 Intermediate Pipe/Hose Nut
    GM784720Courtesy of GENERAL MOTORS CORP.
  1. Carefully install the bank 1 intermediate pipe/hose.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Reconnect the EGR pipe.

    Tighten:  Tighten the EGR pipe to 60 N.m (44 lb. ft.).

  3. Install the nuts securing the bank 1 intermediate pipe/hose to the AIR shut-off valve bracket and the transaxle.

    Tighten:  Tighten the nuts to 9 N.m (80 lb. in.).

  4. Install the hose and pinch clamp connecting the bank 1 intermediate pipe/hose to the AIR shut-off valve.
  5. Install the hose and pinch clamp connecting the bank 1 intermediate pipe/hose to the AIR crossover pipe/hose.
scientia non olet · About Mike's Workshop Manuals