Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 3: This DTC detects an open stop lamp switch signal circuit from the stop lamp side of the splice pack to the EBCM.
- 4: This step verifies that the stop lamps are operating properly.
DTC C1295
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Step 4 | Go to Step 3 |
| 3 | Test the signal circuit of the stop lamp switch for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 5 |
| 4 | Press the brake pedal. Are all of the stop lamps ON? |
Go to Step 5 | Go to Stop Lamps Inoperative in Lighting Systems |
| 5 | Inspect for poor connections at the harness connector of the electronic brake control module (EBCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 6 | Replace the EBCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 7 | - |
| 7 |
|
Go to Step 2 | System OK |