Test Description

The number below refers to the step number on the diagnostic table.

4: Use the scan tool in order to verify that the Brake Thermal Model is exceeded.

DTC C1238

Step	Action	Yes	No
Schematic Reference: ABS Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Install a scan tool. Turn ON the ignition, with the engine OFF. Select the display DTCs function on the scan tool for the electronic brake control module (EBCM). Does the scan tool display that this DTC is set current?	Go to Step 4	Go to Step 3
3	Since most occurrences of this DTC are caused by excessive braking, review with the customer to verify the conditions under which the DTC set. Did vehicle operation cause this DTC to set?	Go to Diagnostic Aids	Go to Step 4
4	Allow 30 minutes from the last time you drove the vehicle for the cooling of the brake rotors. With a scan tool, observe the Brake Temp Status parameter in the DRP/ABS/TCS data list. Does the scan tool display Normal?	Go to Step 6	Go to Step 5
5	Inspect the alignment of the stop lamp switch. Refer to Stop Lamp Switch Replacement in Lighting Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 6
6	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset as a current DTC?	Go to Step 7	System OK
7	Replace the EBCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
8	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK