Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 5.7L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAP Sensor Electrical Connector
    GM55819Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 5.7L.
  2. Disconnect the MAP sensor electrical connector.
    3. Fig 2: Manifold Absolute Pressure (MAP) Sensor
    GM58838Courtesy of GENERAL MOTORS CORP.
  3. Pull the MAP sensor forward in order to release the sensor from the retainer.
  4. Lift the MAP sensor upward.
scientia non olet · About Mike's Workshop Manuals