Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.8L - Introduction >> Repair Instructions >> Knock Sensor (KS) Replacement - Bank 1 >> Removal Procedure

Removal Procedure

    Fig 1: View Of Right Knock Sensor And Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Reposition the wiring harness heat shield to obtain access.
  4. Disconnect the knock sensor (KS) electrical connector.
    5. Fig 2: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  5. Remove the KS bolt.
  6. Remove the KS.
scientia non olet · About Mike's Workshop Manuals