Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.8L - Introduction >> Repair Instructions >> Heated Oxygen Sensor (HO2S) Replacement Bank 1 Sensor 2 >> Removal Procedure

Removal Procedure

  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: View Of HO2S Electrical Connector, Sensor 2 (Bank 1 Shown, Bank 2 Similar)
    GM1201222Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the heated oxygen sensor (HO2S) electrical connector.
  4. Remove the HO2S wiring harness from the transmission case.
    5. Fig 2: View Of HO2S - Replacement Bank 1, Sensor 2
    GM1306431Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Oxygen Sensor Notice in Cautions and Notices.
    IMPORTANT: Removal of the oxygen sensor is easier when the engine temperature is above 48°C (120°F).
  5. Remove the HO2S.
scientia non olet · About Mike's Workshop Manuals