Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.8L - Introduction >> Repair Instructions >> Heated Oxygen Sensor (HO2S) Replacement Bank 1 Sensor 1 >> Removal Procedure

Removal Procedure

    Fig 1: View Of HO2S Electrical Connector - Replacement Bank 1, Sensor 1
    GM887894Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
  3. Remove the HO2S electrical connector from the wiring harness bracket.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. NOTE: Refer to Oxygen Sensor Notice in Cautions and Notices.
    IMPORTANT: Removal of the oxygen sensor is easier when the engine temperature is above 48°C (120°F).
    Fig 2: View Of HO2S - Replacement Bank 1, Sensor 1
    GM887896Courtesy of GENERAL MOTORS CORP.
  5. Remove the HO2S from the catalytic converter.
scientia non olet · About Mike's Workshop Manuals