Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Shift Control Linkage Rod & Adjustment Nut
    GM830370Courtesy of GENERAL MOTORS CORP.
  2. Remove the adjustment nut from the shift control linkage.
  3. Disconnect the shift control linkage rod from the shift control assembly.
  4. Lower the vehicle.
    5. Fig 2: View Of Shift Control Trim Plate
    GM891692Courtesy of GENERAL MOTORS CORP.
  5. Remove the shift control trim plate by lifting the rear of the trim plate up. Pull the plate rearward in order to disengage the front retaining tabs.
  6. Remove the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console
    7. Fig 3: View Of Shift Control Assembly Electrical Connector
    GM891701Courtesy of GENERAL MOTORS CORP.
  7. Remove the electrical connector (1) from the shift control assembly.
    8. Fig 4: View Of Shift Indicator Lamp Sockets & Shift Lock Control Pigtail Wiring Harness Connector
    GM891687Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the wiring harness connector (3) from the shift lock control pigtail connector.
    9. Fig 5: View Of Shift Control Assembly
    GM891704Courtesy of GENERAL MOTORS CORP.
  9. Remove the 4 nuts securing the shift control assembly to the tunnel reinforcement.
  10. Remove the shift control assembly from the tunnel reinforcement.
scientia non olet · About Mike's Workshop Manuals