Test Description

The number below refers to the step number on the diagnostic table.

Traction Off Indicator Always On

Step	Action	Yes	No
Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views
1	Did you perform the ABS Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - ABS (W/O JL4) or Diagnostic System Check - ABS (W/JL4)
2	Turn OFF the ignition for 5 seconds. Turn ON the ignition while observing the traction off indicator. Does the traction off indicator illuminate for approximately 2 seconds and then turn OFF?	Go to Diagnostic Aids	Go to Step 3
3	Select the Instrument Panel Cluster Special Functions menu on the scan tool. Select Lamp Tests. Command the IPC indicator lamps Off. Does the traction off indicator turn OFF?	Go to Step 5	Go to Step 4
4	Replace the instrument panel cluster. Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages, and Console. Did you complete the replacement?	Go to Step 6	-
5	IMPORTANT: Following EBCM replacement, perform the set-up procedure for the EBCM and use the scan tool to perform the Tire Size Calibration procedure. Replace the EBCM. Refer to Electronic Brake Control Module Replacement (w/ JL4) or Electronic Brake Control Module Replacement (w/o JL4) .Did you complete the replacement?	Go to Step 6	-
6	Turn OFF the ignition for 5 seconds. Turn ON the ignition while observing the traction off indicator. Does the traction off indicator illuminate for approximately 2 seconds and then turn OFF?	System OK	Go to Step 3