Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2004 >> DeVille Protection Series >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T80-E (Introduction, Service & Replacement) >> Repair Instructions >> Oil Pressure Test Plug Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Oil Pressure Test Plug
    GM784411Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the oil pressure test plug (1).

    Tighten:  Tighten the oil pressure test plug to 12 N.m (106 lb in).

  2. Install the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Control-4.6L.
scientia non olet · About Mike's Workshop Manuals