Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.6L - Introduction >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Reposition the wiring harness heat shield to obtain access.
    4. Fig 1: Disconnecting Crankshaft Position (CKP) Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  4. Disconnecting crankshaft position (CKP) electrical connector (3).
    5. Fig 2: Removing Crankshaft Sensor Bolt
    GM1311144Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft sensor bolt.
  6. Remove the crankshaft sensor.
scientia non olet · About Mike's Workshop Manuals