Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls - 5.7L - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Pressing Fuel Tank Pressure Sensor Into Fuel Tank
    GM802790Courtesy of GENERAL MOTORS CORP.
  1. Press the fuel tank pressure sensor into the fuel tank, until the locking tabs are fully seated.
  2. Close the retaining strap.
  3. Connect the electrical connector to the fuel tank pressure sensor.
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About Mike's Workshop Manuals