Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.6L & 3.2L - Introduction >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Camshaft Position (CMP) Sensor Pigtail
    GM785859Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector from the camshaft position (CMP) sensor pigtail.
  2. Remove the knock sensor (KS) pigtail retaining clip from the CMP sensor.
  3. Remove the bolt securing the CMP sensor to the camshaft bearing cap.
  4. Remove the CMP sensor from the camshaft bearing cap.
scientia non olet · About Mike's Workshop Manuals