Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Seville SLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 418 (Seat System) >> Repair Instructions >> Power Recliner Sensor Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the recliner sensor to the recliner motor.
  2. Slide the recliner shaft back through the recliner sensor and the recliner motor.
    Fig 1: Connecting Recliner Sensor And Recliner Motor
    G02100013Courtesy of GENERAL MOTORS CORP.
  3. Install the retaining clip to the recliner shaft.
  4. Connect the recliner motor electrical connector.
  5. Install the seat back trim cover. Refer to SEAT BACK TRIM REPLACEMENT - FRONT  .
    Fig 2: Installing Retaining Clip
    G02100014Courtesy of GENERAL MOTORS CORP.
  6. Install the lower seat belt retractor trim cover (2).
  7. Install the push pin fastener (1)
  8. Install the front bucket seat. Refer to SEAT REPLACEMENT - BUCKET  .
    Fig 3: Installing Lower Seat Belt Retractor Trim Cover And Push Pin Fastener
    G02100015Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals