Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Intake Plenum Switchover Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Plenum Switchover Solenoid Bolts
    GM819408Courtesy of GENERAL MOTORS CORP.
  1. Position the intake plenum switchover solenoid to the intake plenum.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intake plenum switchover solenoid bolts.

    Tighten:  Tighten the intake plenum switchover solenoid bolts to 8 N.m (71 lb in).

    3. Fig 2: Locating Intake Plenum Switchover Solenoid Electrical Connector
    GM785855Courtesy of GENERAL MOTORS CORP.
  3. Connect the following to the (2):
    • The electrical connector (1)
    • The vacuum hoses
scientia non olet · About Mike's Workshop Manuals