Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 641 (Lighting Systems (Introduction And Removal & Installation)) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Brake Pedal Position Sensor
    GM1233592Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector on the switch.
  2. Align the brake panel position switch to the stud (3).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt (1) securing the brake panel position switch to the brake panel bracket.

    Tighten:  Tighten the bolt (1) to 9 N.m (80 lb in).

  4. Install the driver side I/P insulator closeout panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  5. Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration Description and Operation .
scientia non olet · About Mike's Workshop Manuals