Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 640 (Engine Controls - 5.7L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing CMP Sensor
    GM55308Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor retaining bolt.

    Tighten:  Tighten the CMP to 25 N.m (18 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 5.7L
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About Mike's Workshop Manuals