Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 637 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Intake Manifold Runner Control Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intake manifold runner control solenoid.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing Intake Manifold Runner Control Solenoid Bolts
    GM1285195Courtesy of GENERAL MOTORS CORP.
  2. Install the intake manifold runner control solenoid bolts.

    Tighten:  Tighten the intake manifold runner control solenoid bolts to 10 N.m (89 lb in).

  3. Install the upper intake manifold. Refer to Intake Manifold Replacement - Lower in Engine Mechanical - 3.6L (LY7).
scientia non olet · About Mike's Workshop Manuals