Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Antilock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Replacement (CTS) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: For safety reasons, the brake pressure modulator valve assembly must not be repaired, the complete unit must be replaced. With the exception of the EBCM, no screws on the brake pressure modulator valve assembly may be loosened. If screws are loosened, it will not be possible to get the brake circuits leak-tight and personal injury may result.
  1. Turn OFF the ignition.
    2. IMPORTANT: The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of disassembled ABS components.
  2. Thoroughly clean all contaminants from around the EBCM.
    3. IMPORTANT: It is not necessary to drain the coolant or disconnect the coolant lines from the coolant bypass valve.
  3. Disconnect the coolant bypass valve from the radiator and position out of the way. Refer to Coolant Bypass Valve Replacement in Engine Cooling.
    4. CAUTION: Brake fluid may irritate eyes and skin. In case of contact, take the following actions:
    • Eye contact-rinse thoroughly with water.
    • Skin contact-wash with soap and water.
    • If ingested-consult a physician immediately.
    NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
    Fig 1: Identifying Brake Pipes To Brake Pressure Modulator Valve
    GM772876Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Record the location of all brake pipes to the brake pressure modulator valve (BPMV) for use as an aid during installation.
  4. Remove the 2 master cylinder brake pipes (3) from the BPMV (1).
  5. Remove the 4 wheel brake pipes (2) from the BPMV (1).
  6. Clean any brake fluid spillage from the BPMV (1).
  7. If equipped with a brake fluid pressure sensor (4), disconnect the electrical connector, from the brake fluid pressure sensor.
    8. Fig 2: View Of EBCM And Electrical Connector
    GM899234Courtesy of GENERAL MOTORS CORP.
  8. Rotate the EBCM connector tab (2) up to the unlocked position.
    9. NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  9. Disconnect the EBCM electrical connector (1) from the EBCM (3) and position out of the way.
    10. Fig 3: Removing & Installing Electronic Brake Control Module & Brake Pressure Modulator Valve Assembly
    GM771978Courtesy of GENERAL MOTORS CORP.
  10. Remove the 2 BPMV bracket nuts (2).
  11. Remove the EBCM/BPMV assembly (1) from the BPMV bracket.
  12. Remove and discard the 4 EBCM to BPMV screws.
    13. Fig 4: View Of EBCM & BPMV
    GM772017Courtesy of GENERAL MOTORS CORP.
  13. Clean the surface of the EBCM/BPMV assembly.
  14. Remove the EBCM (1) from the BPMV (2).
scientia non olet · About Mike's Workshop Manuals