Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Clean any existing corrosion from the battery terminal, the battery cable bolt and the battery cable.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: View Of Battery Area Mounts And Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the battery negative (2) cable to the battery.
Tighten: Tighten the battery cable bolt to 17 N.m (13 lb ft).
Power Windows calibration:
1. Repeat these steps for each window.
2. Turn the ignition switch to the RUN position.
3. Press the power window switch to the down position. After the window is in the full down position, press and hold the switch in the down position for 3 seconds.
4. Press the power window switch to the up position. After the window is in the full up position, press and hold the switch in the up position for 3 seconds.