Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 481 (Rear Wheel Steering System) >> Repair Instructions >> Rear Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Rear Wheel Steering Lifting and Jacking Notice in Cautions and Notices.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Steering Gear Protection Shield
    GM742182Courtesy of GENERAL MOTORS CORP.
  2. Remove the steering gear protection shield (1) retaining bolts (3).
    3. Fig 2: View Of Electrical Connector
    GM747768Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (1).
    4. NOTE: When removing the rear position cover from the steering gear be careful not to damage to the rear position sensor.
    Fig 3: View Of Rear Wheel Position Sensor, Cover & Retaining Bolts
    GM745262Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear wheel position sensor cover (4) from the steering gear by prying on the cover using the slot.
  5. Remove the rear wheel position sensor retaining bolts (3).
    6. IMPORTANT: Check the inner tie rod boot for wear or damage.
  6. If the boots are damaged replace the steering gear actuator. Refer to Steering Gear Actuator and Cover Replacement .
    7. IMPORTANT: Maintain the sensor position. Do not turn the sensor.
  7. Remove the rear wheel position sensor (2) from the steering gear.
scientia non olet · About Mike's Workshop Manuals