Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement (8.1L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Bracket, Bolts, Nut & Stud (8.1L)
    GM751458Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the generator bracket.
  2. Install the generator bracket stud.

    Tighten:  Tighten the stud to 20 N.m (15 lb ft).

  3. Install the generator bracket bolts and nut.

    Tighten:  Tighten the bolts and nut to 50 N.m (37 lb ft)

  4. Install the generator. Refer to Generator Replacement (4.8L, 5.3L, and 6.0L Engines)  or Generator Replacement (8.1L Engine) .
  5. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement in Engine Mechanical - 8.1L.
  6. Install the fan and clutch. Refer to Fan Clutch Replacement in Engine Cooling.
    7. Fig 2: View Of Battery Cable Junction Block Bracket Bolts (8.1L)
    GM759640Courtesy of GENERAL MOTORS CORP.
  7. Install the battery cable junction block bracket bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

scientia non olet · About Mike's Workshop Manuals