Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 1992 >> Seville Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls - Tests W/Codes) >> Pcm Trouble Code Diagnosis >> Pcm Code E13, Oxygen (O2) Sensor Not Ready >> Action

Pcm Code E13, Oxygen (O2) Sensor Not Ready: Action

WARNING: This page is about a different car, the 1992 Cadillac Fleetwood and 1992 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.

PCM turns on SERVICE ENGINE SOON light and disables "closed loop".

NOTE: Test numbers refer to numbers on diagnostic chart.
  1. A voltage display of .42-.48 volt is a reference from PCM. O2 sensor must generate a voltage of .15 volt greater or less than .45-volt reference to register O2 sensor cross count in PCM.
  2. PCM compares voltage on circuit No. 412 to ground voltage on circuit No. 413. O2 sensor ground and PCM ground on pin E15 must be at same voltage potential with engine running.
scientia non olet · About Mike's Workshop Manuals