Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2020 >> Envision Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Cooling System) >> Specifications >> Fastener Specifications (3.6L LGX)

Fastener Specifications (3.6L LGX)

WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application
Engine Coolant Air Bleed Pipe Seal
Engine Coolant Thermostat Housing Seal
Heater Inlet and Outlet Pipe Gasket
Water Pump Gasket
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application Specification
Metric (English)
Water Pump Bolt 15N.m (11 lb ft)
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 

Application Specification
Metric (English)
Engine Coolant Air Bleed Pipe Bolt 10N.m (89 lb in)
Engine Coolant Fan Bolt 9N.m (80 lb in)
Engine Coolant Fan Motor Bolt 6N.m (53 lb in)
Engine Coolant Thermostat Housing Bolt 10N.m (89 lb in)
Engine Coolant Thermostat Housing Inlet Pipe Bolt 10N.m (89 lb in)
Ground Nut 9N.m (80 lb in)
Heater Inlet and Outlet Pipe Bolt 9N.m (80 lb in)
Radiator Air Lower Deflector Bolt 2.5N.m (22 lb in)
Radiator Surge Tank Bolt 9N.m (80 lb in)
Radiator Upper Bracket Bolt 7N.m (62 lb in)
Radiator Upper Bracket Nut 7N.m (62 lb in)
Water Pump Inlet Pipe Bolt 15N.m (11 lb ft)
Water Pump Pulley Bolt 10N.m (89 lb in)