Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2020 >> Envision Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Driver Assistance Systems) >> Diagnostic Information and Procedures >> DTC B390C >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify DTC B390C is not set
    • If the DTC is set 
    1. Perform the Radar Sensor Module - Long Range Learn  procedure.
    2. Verify DTC B390C is not set after the calibration procedure has been completed.
      • If the DTC is set after calibration, replace the B233B Radar Sensor Module - Long Range.
      • Go to next step: If the DTC is not set after calibration
    3. All OK.
    • Go to next step: If DTC B390C 66 is not set 
  3. All OK.
scientia non olet · About Mike's Workshop Manuals