Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, 2019 Buick Regal, and 2018 Buick Regal TourX. However, it is still accessible from the selected car via links, so may be relevant.
Battery Positive Cable (4) - Install
- Battery Positive Cable Nut (2) - Install and tighten 16 N.m (12 lb ft)
- Battery Positive Cable Retainer (3) - Engage
- Engine Wiring Harness Junction Block Cover (1) - Install
Battery Positive Cable Retainer (1) - Engage [2x]
Battery Positive Cable Retainer (4) - Engage
- Battery Positive Cable (3) - Install
- Battery Positive Cable Nut (2) - Install and tighten 15 N.m (11 lb ft)
- Protective Cap (1) - Install
Battery Positive and Negative Cable (2) - Install
- Battery Positive Cable Nut (1) - Install and tighten 12.5 N.m (111 lb in)
- Battery Positive and Negative Cable Conduit Bolt (3) - Install and tighten 9 N.m (80 lb in)
Starter Heat Shield (2) - Install - Starter Shield Replacement
Three-Way Catalytic Converter (2) - Install - Three-Way Catalytic Converter Replacement (Bank 1) , or Three-Way Catalytic Converter Replacement (Bank 2)
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (3.6L LGX) , or Battery Negative Cable Disconnection and Connection (2.0L LTG)
CAUTION:
Refer to Fastener Caution