Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Install the generator. (4)

CAUTION:

Refer to Fastener Caution .

Generator Mounting Stud (3) - Install and tighten 9 N.m (80 lb in)
Generator Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft)
Generator Nut (2) - Install and tighten 22 N.m (16 lb ft)
Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Cable (2) - Install
Battery Positive Cable Nut (1) - Install and tighten 15 N.m (11 lb ft)
Electrical Connector (4) - Connect
Fig 1: Drive Belt Routing (LCV Without Generator Shield)
Courtesy of GENERAL MOTORS COMPANY

Drive Belt (1) - Install - Drive Belt Replacement (LCV)
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold (3) - Install - Intake Manifold Replacement (LCV)
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe (1) - Install - Fuel Feed Pipe Replacement (Engine LCV)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Tube (1) - Install - Evaporative Emission Canister Purge Tube Replacement (LCV)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Solenoid Valve Hose (1) - Install - Evaporative Emission Canister Purge Solenoid Valve Hose Replacement (LCV)
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Assembly (1) - Install - Air Cleaner Assembly Replacement (LCV)
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection .