Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Position the steering column (1) in the vehicle.
Fig 1: Steering Column Nuts (With Tightening Sequence)
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Steering Column Nut (1) - Install and hand tighten [4x]
Tighten the steering column nuts (1) in sequence shown to 22 N.m (16 lb ft).
Connect the steering column electrical connectors.
Intermediate Steering Shaft@Steering Column - Install - Intermediate Steering Shaft Replacement
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster (2) - Install - Instrument Panel Knee Bolster Replacement
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct - Left Side (2) - Install - Floor Front Air Outlet Duct Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Steering Column Lower Trim Cover (2) - Install - Steering Column Lower Trim Cover Replacement
Courtesy of GENERAL MOTORS COMPANY

Steering Column Upper Trim Cover (1) - Install - Steering Column Upper Trim Cover Replacement
Program the power steering control module. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering