Installation Procedure

CAUTION:

If necessary, install the generator mounting stud. (2) - Tighten9 N.m (80 lb in)
Generator Nut (1) - Hand Tighten
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Drive Belt (1) - Install - Drive Belt Replacement (LTG) , or Drive Belt Replacement (LCV)
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe (1) - Install - Fuel Feed Pipe Replacement (Engine LTG) , or Fuel Feed Pipe Replacement (Tank) , or Fuel Feed Pipe Replacement (Engine LCV)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Tube (1) - Install - Evaporative Emission Canister Purge Tube Replacement (LTG) , or Evaporative Emission Canister Purge Tube Replacement (LCV)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Solenoid Valve Hose (1) - Install - Evaporative Emission Canister Purge Solenoid Valve Hose Replacement (LTG) , or Evaporative Emission Canister Purge Solenoid Valve Hose Replacement (LCV)
Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Anti-rotation tab is in the 12 o'clock position (arrow).

Battery Positive Cable (3) - Install
Generator Nut (1) - Install and tighten15 N.m (11 lb ft)
Protective Cap (2) - Install
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Remove the generator nut (1).
Courtesy of GENERAL MOTORS COMPANY

Generator Shield (3) - Install - Generator Shield Replacement (LTG) , or Generator Shield Replacement (LCV)