Installation Procedure
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Position a NEW steering gear boot inner clamp (1) on the steering gear boot (2).
Steering Gear Boot (1) - Install
Steering Gear Boot Inner Clamp (1) - Tighten- use DT-35910 Drive Axle Boot Clamp Pliers (2)
Steering Gear Boot Outer Clamp (1) - Install
Install the steering linkage inner tie rod nut (1) until aligned with the previously placed matched mark on the steering linkage inner tie rod.
- Steering Linkage Outer Tie Rod - Install - Steering Linkage Outer Tie Rod Replacement
- Warm Up Three-Way Catalytic Converter - Install - Warm Up Three-Way Catalytic Converter Replacement (2. 0L LTG)
- Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment