Installation Procedure
Electronic Brake Control Module(1) - Install
- Nut(2)@Electronic Brake Control Module - Tighten[2x]9N.m (80 lb in)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pressure Modulator Valve Primary Pipe Fitting(1) - Install and tighten32N.m (24 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pressure Modulator Valve Secondary Pipe Fitting(1) - Install and tighten32N.m (24 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Front-Left Side(1) - Install and tighten18N.m (13 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Rear-Right Side (1) - Install and tighten18N.m (13 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Rear-Left Side(1) - Install and tighten18N.m (13 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Front-Right Side(1) - Install and tighten18N.m (13 lb ft)
Electrical Connector(1)@Electronic Brake Control Module - Disconnect
- Radiator Surge Tank Replacement - Install
- Engine Control Module - Reposition - Engine Control Module Replacement
- Connect the battery negative cable. Refer to ENGINE WIRING HARNESS JUNCTION BLOCK REPLACEMENT (LTG) or ENGINE WIRING HARNESS JUNCTION BLOCK REPLACEMENT (LGX)
- Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual)
- Run all necessary programming and setup procedures. Refer to Control Module References
- Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering
CAUTION: