Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2018 >> LaCrosse Base >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid/EV Control System >> Diagnostic Information and Procedures >> DTC P16F3 >> Circuit/System Verification

Circuit/System Verification

  1. Verify DTC P16F3 is not set.
    • If the DTC is set 
    1. Verify the K59 Starter/Generator Control Module has the latest calibration in Calibration Information.
      • If the K59 Starter/Generator Control Module does not have the latest calibration
      1. Program the control module: K59 Starter/Generator Control Module.
      2. Verify the DTC does not set.
        • If the DTC sets, Replace the component: K59 Starter/Generator Control Module
        • Go to next step: If the DTC does not set
      3. All OK.
      • Go to next step: If the K59 Starter/Generator Control Module has the latest calibration
    2. Replace the component: K59 Starter/Generator Control Module.
    • Go to next step: If the DTC is not set 
  2. All OK.
scientia non olet · About Mike's Workshop Manuals