Installation Procedure

CAUTION:

If necessary, install the generator mounting stud. (2) - Tighten 9 N.m (80 lb in)
Generator Nut (1) - Hand tighten
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Connect
Fig 1: Drive Belt Routing (LCV & LTG With Generator Shield)
Courtesy of GENERAL MOTORS COMPANY

Drive Belt (1) - Install - Drive Belt Replacement (LCV)Drive Belt Replacement (LTG)
Courtesy of GENERAL MOTORS COMPANY

Fuel Feed Pipe (1) - Install - Fuel Feed Pipe Replacement (Engine LTG)Fuel Feed Pipe Replacement (Engine LCV)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Tube (1) - Install - Evaporative Emission Canister Purge Tube Replacement (LTG)Evaporative Emission Canister Purge Tube Replacement (LCV)
Courtesy of GENERAL MOTORS COMPANY

Evaporative Emission Canister Purge Solenoid Valve Hose (1) - Install - Evaporative Emission Canister Purge Solenoid Valve Hose Replacement (LTG)Evaporative Emission Canister Purge Solenoid Valve Hose Replacement (LCV)
Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Anti-rotation tab is in the 12 o'clock position (arrow).

Battery Positive Cable (3) - Install
Generator Nut (1) - Install and tighten 15 N.m (11 lb ft)
Protective Cap (2) - Install
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Remove the generator nut (1).
Courtesy of GENERAL MOTORS COMPANY

Generator Shield (3) - Install - Generator Shield Replacement (LTG) Generator Shield Replacement (LCV)