Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2017 >> LaCrosse Base >> Repair and Diagnosis >> Transmission >> Power Transfer Unit/Transfer Case - AAM >> Repair Instructions - On Vehicle >> Transfer Case Bracket Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Transfer Case Bracket
    GM4441121Courtesy of GENERAL MOTORS COMPANY
  1. Position the bracket (3) to the transfer case.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transfer case-to-transmission bolts (1) and tighten to 22 N.m (16 lb ft).
  3. Install the transfer case-to-transmission bolt (2) and tighten to 58 N.m (43 lb ft).
  4. Install the right wheel drive shaft. FRONT WHEEL DRIVE HALF SHAFT REPLACEMENT - RIGHT SIDE (AWD)FRONT WHEEL DRIVE HALF SHAFT REPLACEMENT - RIGHT SIDE (FWD)
  5. Install the power transfer unit heat shield. Power Transfer Unit Heat Shield Replacement 
  6. Install the catalytic converter. THREE-WAY CATALYTIC CONVERTER REPLACEMENT
scientia non olet · About Mike's Workshop Manuals