Removal Procedure
- Rear Compartment Side Trim-Left Side 2 - Remove - Rear Compartment Side Trim Replacement - Left Side (With LHN)Rear Compartment Side Trim Replacement - Left Side (With LGX)
- Place a suitable open ended wrench on the battery sensor terminal, to prevent damage to the battery sensor. 2
- Battery Negative Cable Nut 1 - Remove
- Battery Negative Cable 4 - Remove
- Electrical Connector 3 - Disconnect
- Battery Post Negative Cable Clamp Nut 1 - Loosen
- Battery Sensor Module 2 - Remove
WARNING:
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.